Saab 2005 9-7X User Manual download pdf (Page 104)

Programming HomeLink

Your vehicle’s engine should be turned off while

programming the transmitter. Follow these steps to

program up to three channels:

1. Press and hold down the two outside buttons,

releasing only when the indicator light begins to

ﬂash, after 20 seconds. Do not hold down the

buttons for longer than 30 seconds and do not

repeat this step to program a second and/or third

transmitter to the remaining two HomeLink

buttons.

2. Position the end of your hand-held transmitter about

1 to 3 inches (3 to 8 cm) away from the HomeLink

buttons while keeping the indicator light in view.

3. Simultaneously press and hold both the desired

button on HomeLink

and the hand-held transmitter

button. Do not release the buttons until Step 4

has been completed.

Some entry gates and garage door openers may

require you to substitute Step 3 with the procedure

noted in “Gate Operator and Canadian

Programming” later in this section.

4. The indicator light will ﬂash slowly at ﬁrst and then

rapidly after HomeLink

successfully receives the

frequency signal from the hand-held transmitter.

Release both buttons.

5. Press and hold the newly-trained HomeLink

button

and observe the indicator light.

If the indicator light stays on constantly, programming

is complete and your device should activate when the

HomeLink

button is pressed and released.

To program the remaining two HomeLink

buttons,

begin with Step 2 under “Programming HomeLink

.”

Do not repeat Step 1 as this will erase all of the

programmed channels.

If the indicator light blinks rapidly for two seconds

and then turns to a constant light, continue with

Steps 6 through 8 following to complete the

programming of a rolling-code equipped device

(most commonly, a garage door opener).

6. Locate in the garage, the garage door opener

receiver (motor-head unit). Locate the “Learn”

or “Smart” button. This can usually be found

where the hanging antenna wire is attached

to the motor-head unit.

7. Firmly press and release the “Learn” or “Smart”

button. The name and color of the button may

vary by manufacturer.

You will have 30 seconds to start Step 8.

2-38

2005 - Saab 97X Owner Manual

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 397 398

Comments to this Manuals

No comments

Saab 2005 9-7X User Manual Page 104

Comments to this Manuals

Related products and manuals for Cars Saab 2005 9-7X