Saab 2008 9-5 User Manual Page 188

  • Download
  • Add to my manuals
  • Print
  • Page
    / 288
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 187
188 Starting and driving
9 Attach the cable at least 18 inches
(45 cm) away from the discharged
battery, but not near engine parts that
move. To avoid an arc which could deto-
nate the hydrogen gas around the
battery, the final connection must be at
least 18 from the battery.
10 Start the vehicle with the good battery
and run the engine for a while.
11 Try to start the vehicle with the
discharged battery. If it does not start
after a few tries, it probably needs
service.
12 Remove the cables in reverse order to
prevent electrical shorting. Take care
that they do not touch each other or any
other metal.
Charging the battery/Jump
starting
To avoid damaging the cars electrical
system and electronics, the following rules
must be followed when charging the battery
or jump starting the car.
If the charger 3 or starter unit 3 can be
set to different voltages
(6V/12V/18V/24V), 12V must be
selected.
Follow the manufacturers instructions
supplied with the charger or starter unit.
Nothing that is plugged into an electrical
outlet should be connected to the car
during charging or jump starting.
The charger or starter unit must under no
conditions produce a voltage greater
than:
16V continuous
18V for 60 min.
If you are unsure about the charge rating
of the unit, disconnect the battery clamp
from the positive terminal before connect-
ing the unit to the battery.
WARNING
Do not let the other end touch anything
until the next step. The other end of the
negative cable does not go to the dead
battery. It goes to a major metal part with
a good ground on the engine of the vehi-
cle with the discharged battery.
95_US_M08.book Page 188 Friday, May 11, 2007 1:06 PM
Page view 187
1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 287 288

Comments to this Manuals

No comments